5J.J0T05.001 lamp usage replacing and time

Timing of replacing the lamp

When the 5J.J0T05.001 Lamp indicator lights up red or a message appears suggesting it is time to replace

the lamp, please install a new 5J.J0T05.001 lamp or consult your dealer. An old lamp may cause a

malfunction in the projector and in some instances the lamp may explode

The LAMP indicator light and TEMPerature warning light will light up if the lamp becomes too

hot. Turn the power off and let the projector cool for 45 minutes. If the Lamp or Temp indicator

still lights up after turning the power back on, please contact your dealer

The lamp has been in operation equivalent to 2950

hours. A new lamp should be fitted to avoid the

inconvenience when the projector runs out of

lamp time

The lamp has been in operation equivalent to 3000

hours.

It is strongly recommended that you replace the

5J.J0T05.001 lamp at this age. The lamp is a consumable item.

The lamp brightness diminishes with use. This is

normal lamp behavior. You can replace the lamp

whenever you notice that the brightness level has

significantly diminished. If the lamp is not

replaced beforehand, it must be replaced after

3000 hours usage.

Replacing the lamp

• To reduce the risk of electrical shock, always turn the projector off and disconnect the

power cord before changing the lamp.

• To reduce the risk of severe burns, allow the projector to cool for at least 45 minutes

before replacing the lamp.

• To reduce the risk of injuries to fingers and damage to internal components, use caution

when removing lamp glass that has shattered into sharp pieces.

• To reduce the risk of injuries to fingers and/or compromising image quality by touching

the lens, do not touch the empty lamp compartment when the lamp is removed.

• This lamp contains mercury. Consult your local hazardous waste regulations to dispose of

this lamp in a proper manner.

• To assure optimal performance from the projector, it is recommended that you purchase a

qualified projector lamp for lamp replacement.

• If lamp replacement is performed while the projector is suspended upside-down from the

ceiling, make sure that no one is underneath the lamp socket to avoid any possible injury

or damage to the human eyes caused by fractured lamp.