AN-F212LP lamp usage 

Caution concerning the lamp unit

Potential hazard of glass particles

if lamp ruptures. In case

of lamp rupture, contact your

nearest Sharp Authorized

Projector Dealer or Service

Center for replacement.

Note

•About the AN-F212LP Lamp Indicator

The lamp indicator illuminates to indicate the

status of the lamp.

Green: The lamp is on.

Blinking in green: The lamp is warming up.

Red: The lamp is shut down abnormally

or the lamp should be replaced.

•When switching on the projector, a slight flickering

of the image may be experienced within the

first minute after the lamp has been illuminated.

This is normal operation as the lamp’s control

circuitry is stabilising the lamp output characteristics.

It should not be regarded as faulty

operation.

•If the projector is put into standby mode and

immediately turned on again, the lamp may take

some time to start projection.

•When System Lock is set, the keycode input box

appears. To cancel the keycode setting, input the

keycode that you have already set. See page 47

for details.

Caution Concerning the Lamp

Replacing the lamp

Info

• Make sure to reset the AN-F212LP lamp timer only when

replacing the lamp. If you reset the lamp timer

and continue to use the same lamp, this may

cause the lamp to become damaged or explode.