SP.8MY01GC01 projector lamp replacement

Lamp Replacement Procedure:

1. Switch off the power to the projector by pressing the “ ” button.

2. Allow the projector to cool down for at least 30 minutes.

3. Disconnect the power cord.

4. Unscrew the two screws on the cover. 

5. Lift up and remove the cover. 

6. Unscrew the two screws on the lamp module. 

7. Lift up the SP.8MY01GC01 lamp handle and remove the lamp module slowly and carefully. 

To replace the lamp module, reverse the previous steps.

8. Turn on the projector and use “Lamp Reset” after the lamp module is

replaced.

Precaution:

Warning- Do not look into the projector’s lens when the lamp is on. The bright light may hurt and damage your eyes.

Warning- When replacing the lamp, please allow the unit to cool down.

Warning- This projector will detect the life of the lamp itself. Please be sure to change the lamp when it shows warning messages.

Warning: To reduce the risk of personal injury, do not drop the lamp module or touch the lamp bulb. The bulb may shatter and cause injury if it is dropped.

Lamp Reminder

Choose this function to show or to hide the warning message when the changing lamp message is displayed.

The message will appear 30 hours before suggested replacement of lamp

Lamp Reset

Reset the SP.8MY01GC01 lamp hour counter after replacing the lamp.