DT00231  lamp replacement and time  

Reset Lamp Hours

1. To display the total DT00231 lamp hours, press and hold for 3 seconds, the RESET button on the projector or

Timer button on the remote control.

2. To reset the DT00231 lamp timer, press the RESET button on the projector or MENU button on the remote

while the total lamp hours are displayed. Use the arrow button on the projector or the DISC PAD to

select 0 (or CANCEL).

Replacing the Lamp

To reduce the risk of electrical shock, always turn off projector and disconnect power cord before changing

lamp.

To reduce the risk of severe burns, allow the projector to cool for at least 30 minutes before replacing the

lamp.

To reduce the risk of cuts to fingers and damage to internal components, use caution when removing lamp

glass that has failed and shattered into sharp pieces.

For maximum DT00231 lamp life, do not apply shock, handle or scratch the lamp glass when it is hot. Also, do not use

an old or previously used lamp as a replacement lamp.

All lamp module screws must be loosened. These screws are self-containing screws that cannot be removed

from the lamp module or access door.

To reduce the risk of cuts to fingers from sharp metal fittings and/or decreasing image quality by touching

the lens, do not insert hand into the empty lamp compartment when the lamp has been removed.