ET-LAB2 lamp replacement and hours

The lamp has been used for longer than its rated useful life, and it is time to replace it

The ET-LAB2 lamp has high internal pressure. If improperly handled, an explosion and severe injury or accidents 

will result

Replacement of the lamp should be carried out by a  qualified technician.

The lamp can easily explode if struck against hard  objects or dropped.

Before replacing the lamp, be sure to disconnect the  power plug from the wall outlet.

Electric shocks or explosions can result if this is not done.

When replacing the lamp, allow it to cool for at least  one hour before handling it otherwise it can cause 

burns.

The brightness of the lamp will decrease over time. 

The lamp may explode or shorten the lamp life by  shocks or chipping damage.

In rare cases, it may burst shortly after the first use. 

The possibility of its bursting increases when the lamp is used beyond the replacement time.

If the ET-LAB2 lamp bursts, gas inside the lamp is released in the form of smoke.

The life of a mercury lamp varies according to the individual difference or conditions of use.

In particular, turning the power on and off frequently  and/or repeatedly as well as continuous use for 

10 hours will greatly affect the life cycle. Provide a lamp for replacement in advance.

Handle the lamp unit with special care as the lamp is made of glass.  

Dropping or giving it a shock may cause it to burst or damaged.

If you wish to discard the used lamp, please contact your local   

authorities or dealer and ask for the correct method of disposal.

Prepare a Phillips-head screwdriver. 

When replacing the lamp unit, be sure to hold it by the handle. 

Hold the lamp unit horizontally to prevent broken pieces from scattering.  

When the projector is mounted in the ceiling, do not work 

directly under the projector or put your face close to the projector. 

Pull out the lamp vertically.

Lamp unit replacement time

When the ET-LAB2 lamp has expired, the brightness may decrease over time. 4 000 hours of use is a rough guide 

of the replacing time and that might be shortened due to usage conditions, specifications of the lamp unit 

or environmental conditions. You can check the duration of usage time by checking LAMP RUNTIMEin the 

PROJECTOR SETUPmenu. Do not use a lamp unit over 5 000 hours. Failure to observe this may result in 

explosion of the lamp