replacing SP-LAMP-025 projector lamp

Replacing the projection lamp

1Turn off the projector and unplug the power cord. If ceiling mounted, disconnect all cables

 and detach the projector from the ceiling mount.

2Wait 60 minutes to allow the projector to cool thoroughly.

3Turn the projector upside down on a soft cloth so that the lamp door is facing you. Remove t

he base or ceiling mount plate, if attached, by removing the 3 screws.

4Push the 2 tabs on the lamp door toward the front of the projector and lift the lamp door off.

5Loosen the three captive screws that attach the lamp housing to the projector.

6Detach the lamp connector from the projector by depressing the locking tab on the connector 

and lightly pulling it free.

7Carefully remove the lamp housing. Dispose of the lamp in an environmentally proper manner.

8Install the new SP-LAMP-025 lamp housing and tighten the screws.

9Re-attach the lamp connector to the projector. The locking tab should engage when the 

connector is fully plugged in.

10Replace the lamp door.

11Replace the base or ceiling mount plate, if necessary.

12Plug in the power cord and press the Power button on the remote or keypad to turn the

 projector back on.

13To reset the lamp hour timer, navigate to the Settings>Service menu and select Reset Lamp Hours.

WARNING:

To avoid burns, allow the projector to cool for at least 60 minutes before you replace the lamp.

Be extremely careful when removing the lamp housing. In the unlikely event that the bulb ruptures, 

small glass fragments may be generated. The lamp housing is designed to contain these fragments, 

but use caution when removing the lamp housing. Before replacing the lamp, clean the SP-LAMP-025 lamp 

compartment and dispose of cleaning materials. Wash hands after lamp replacement. This product has 

a lamp which contains a very small amount of mercury. Dispose of it as required by local, state or federal 

ordinances and regulations.

NOTE: 

You can order new SP-LAMP-025 lamp housings from your retailer or your dealer. Use only a replacement lamp 

with the same type and rating as the original lamp.

Reset Lamp hours: 

resets the lamp hours used counter in the Service Info menu to zero. Do this only after changing the lamp.