replacing SP-LAMP-039 projector lamp

Replacing the projection lamp

1 Turn off the projector and unplug the power cord.

2 Wait 60 minutes to allow the projector to cool thoroughly.

3 Remove the lamp door by (a) removing the screw on the side of the

lamp door, (b) sliding the door forward, and (c) lifting the door off.

4 Loosen the two captive screws that attach the lamp housing to the projector.

Carefully remove the lamp housing. Dispose of the lamp in an

environmentally proper manner.

5 Install the new lamp housing and tighten the screws.

6 Replace the lamp door by sliding it into place and replacing the screw.

7 Plug in the power cord and press the Power button to turn the projector

back on.

8 To reset the lamp hour timer, navigate to the Status and Service menu

and select Reset Lamp Hours.

WARNINGS:

• To avoid burns, allow the projector to cool for at least 60 minutes before

you replace the lamp.

• Only genuine InFocus SP-LAMP-039 lamps are tested with this projector. Use of other

lamps may cause electrical shock and fire.

• Unplug the power cord before replacing the lamp.

• Do not drop the lamp module. The glass may shatter and cause injury.

• Do not touch the glass lamp screen. Fingerprints can obscure projection

sharpness.

• Be extremely careful when removing the lamp housing. In the unlikely

event that the lamp ruptures, small glass fragments may be generated.

The lamp module is designed to contain most of these fragments, but

use caution when removing it. Before replacing a ruptured lamp, clean

the lamp compartment and dispose of cleaning materials. Wash hands

after lamp replacement.

Lamp Low Power: toggles between on and off. Turn it on to lower the light

output of the SP-LAMP-039 lamp. This also lowers the fan speed, making the projector

quieter.

Reset Lamp Hours: resets the lamp hours used counter in the Projector Info

menu to zero. Do this only after changing the lamp.