replacing SP-LAMP-058 projector lamp

Important Operating Considerations for Safety

Only genuine InFocus lamps are tested for use in this projector. Use of non

InFocus lamps may cause electrical shock and fire, and may void the projector

warranty.

• Hg – Lamp contains mercury. Manage in accordance with local

• The projector uses a high-pressure mercury glass lamp. The lamp may fail

prematurely, or it may rupture with a popping sound if jolted, scratched, or

handled while hot. The risk of lamp failure or rupture also increases as the

lamp age increases; please replace the lamp when you see the “Replace Lamp”

message.

Replacing the projection lamp

1 Turn off the projector and unplug the power cord.

2 Wait 60 minutes to allow the projector to cool thoroughly.

3 Remove the top front cover by (a) removing the screws on the two sides of the

projector, and (b) lifting the top front cover off.

4 Loosen the two captive screws that attach the lamp housing to the projector.

5 Using the handle, carefully remove the lamp housing. Dispose of the lamp in an

environmentally proper manner in accordance with local disposal laws.

6 Install the new lamp housing, pressing the SP-LAMP-058 lamp into place.

7 Tighten the captive screws.

8 Replace the top front cover and tighten both screws.

9 Plug in the power cord and press the Power button to turn the projector back on.

10 To reset the lamp hour timer, navigate to the Status and Service menu and

select Reset Lamp Hours.

WARNINGS:

• The projector uses a high-pressure mercury glass lamp. The lamp may fail

prematurely, or it may rupture with a popping sound if jolted, scratched, or

handled while hot. The risk of lamp failure or rupture also increases as the

lamp age increases; please replace the SP-LAMP-058 lamp when you see the “Replace Lamp”

message.

• To avoid burns, allow the projector to cool for at least 60 minutes before you

replace the SP-LAMP-058 lamp.

• Unplug the power cord before replacing the lamp.

• Do not drop the lamp module. The glass may shatter and cause injury.

• Do not touch the glass surface of the lamp module. Fingerprints can obscure

projection sharpness and may cause the glass to shatter.