SP-LAMP-LP1/ XD10M-930 projector lamp replacement and lamp hours

Lamp hours used

Indicates how many hours the current SP-LAMP-LP1 lamp has been in use. The

counter starts at zero hours and counts each hour the lamp is in

use. Replace the bulb when the brightness is no longer acceptable.

Replacing the Projection Lamp

Follow these steps to replace the projection SP-LAMP-LP1 lamp:

1 Turn off the projector and unplug the power cord.

2 Wait 30 minutes to allow the projector to cool thoroughly.

3 Insert a small screwdriver or other flat object into the slot near

the front of the projector. Slide the screwdriver toward the

back of the projector to disengage the lamp access grill, then

slide the lamp access grill off (away from the lens).

4 Pull the yellow tab on the lamp module.

5 Loosen the captive screw on the lamp module.

6 Grasp the pull tab to pull the lamp module out. Dispose of the

lamp module in an environmentally proper manner.

7 Install the new lamp module.

8 Tighten the screw on the outside of the module.

9 Press the yellow tab to reconnect the lamp module.

10 Replace the lamp access grill by lining up the ribs on the grill

with the marks on the bottom case and sliding the grill in the

direction of the arrows on the bottom case.

11 Plug in the power cord and press the Power switch to turn the

projector back on.

12 To reset the lamp hour counter in the Status menu, press and

hold the reset button, then press the menu/select button (while

still holding down the reset button) for 10 seconds.

Verify that the counter was reset by pressing the menu/select

button and viewing the counter in the Status menu. See

page 25 for details on the Status menu.

Troubleshooting

Problem: Projector is running, but nothing appears on projection

screen

•Make sure you have removed the lens cap on the projection

lens at the front of the projector.

•Check the projector’s lamp to ensure that it is securely connected

in the lamp module. Make sure the SP-LAMP-LP1 lamp access grill is

installed.

Problem: Lamp seems to be getting dimmer

•The lamp begins to lose brightness when it has been in use for

a long time.

Problem: Lamp shuts off

•A minor power surge may cause the lamp to shut off. Unplug

the projector, wait at least a minute, then plug it back in.

•Make sure the vents are not blocked.