Usage attention SP-LAMP-LP9 lamp 

•Do not look directly into the projection lens when the SP-LAMP-LP9

 lamp is turned on. The bright light may harm your eyes.

• Do not block the grills on the projector. Restricting the air flow 

can cause it to overheat and turn off. If this happens, you must 

wait a minute before attempting to turn it back on.

• Handle the projector as you would any product with glass 

components. Be especially careful not to drop it.

• Avoid leaving the projector in direct sunlight or extreme cold 

for extended periods of time. If this happens, allow it to reach 

room temperature before use.

Turning Off the Projector

If you want to blank the screen for a short period of time, press 

the standby button on the keypad or remote. This blanks the 

screen for fifteen minutes, but keeps the projector running. (You 

can change the amount of time the projector stays in standby 

mode; see “Standby Time” on page 30 for details.) After the 

standby time, the projector shuts off. To exit standby mode, press 

the standby button again.