TDPLD2 projector lamp replacement 

Lamp replacement

PRECAUTIONS

• Before unplugging the power cord or turning off the main power switch, make sure that

the LAMP indicator is off. Unplugging the power cord or turning off the main power

switch and cutting off the power while the projector is running or being cooled will

shorten the life of the lamp. However, please unplug the power cord if the projector

locks up or acts abnormally.

• If the power cord is unplugged before cooling is complete, give the lamp time (about 10

minutes) to cool before plugging it back in. If the lamp overheats it may fail to light, and

its lifetime will be shortened.

Notes

• Note that the TDPLD2 lamp characteristics may rarely cause the brightness to fluctuate slightly.

• A lamp is consumable supplies.

If used for extended periods, images will appear dark, and the lamp could burn out. This

is characteristic of a lamp, and is not malfunction. (The lifetime of the lamp depends on

conditions of use.)

CAUTION

• Request cleaning and maintenance of a ceiling-mounted unit from your projector

dealership.

• When replacing, always use the specified lamp (for TDP-D1: TDPLD1 and it for TDPD2:

TDPLD2) (sold separately).

• If you have been using the projector, the lamp will be very hot, and may cause burn

injuries.

Wait for the TDPLD2 lamp to cool (for longer than 1 hour) before replacing it.