TLPLU6 projector lamp replacement and caution

Lamp replacement

The TLPLU6 lamp will eventually begin to project dark

or dull pictures and finally will not light up.

(Lamp’s life length depends on the use

condition.) In such a case, replace the lamp

with new one.

1. Unplug the power cord.

2. Wait until the TLPLU6 lamp gets cold

   enough.

3. Take off the lamp cover on the

   bottom panel.

   Loosen two screws, and pull off the lamp

   cover.

4. Load a new lamp.

   Slide until it hits the bottom and tighten

   the two fixed screws.

5. Attach the lamp cover.

   Slide the cover in place and tighten two

   screws.

6. Reset the lamp timer.

   Refer to the lamp instructions for

   resetting.

Notes

• The projector displays the total working time

at every 1,000 hours (only when plugged in

and turned on; ex. “ >1000H ”, “ >2000H ”).

• The lamp should be replaced if the total

working time exceeds about 2,000 hours.

• Attach the lamp cover firmly after replacing

the lamp. If it is not set correctly, the power

will not turn on.

• Use a new lamp when replacing it.

• The lamp is made of glass and is very fragile.

Do not touch the lamp with your bare hands

and do not jolt or damage it. Do not use an

exhausted lamp.

CAUTION

• If you use the projector mounted on the

ceiling, ask the dealer to carry out the

maintenance such as cleaning or

replacement of the lamp.

• When replacing, always use lamp “TLPL6”

(for TLP450U, TLP451U, TLP650U,

TLP651U, TLP470U, TLP471U, TLP670U,

TLP671U) or “TLPL8” (for TLP650A,

TLP651A) (sold separately). For detail, refer

to the lamp instruction.

• If you have been using the projector, the

lamp will be very hot, and may cause burn

injuries. Wait for the lamp to cool (for longer

than 1 hour) before replacing it.

• If the TLPLU6 lamp should break, please handle with

care to avoid injury due to broken pieces

and contact your dealer for repair service.