VLT-HC7000LP lamp replacement and time  

Replacing the VLT-HC7000LP lamp

This projector is equipped with a lamp to project images. This lamp is a consumable. It may burn out or its brightness 

may decrease during use. In such cases, replace the lamp with a new one as soon as possible. Be sure to replace the 

lamp with a new lamp sold separately that is exclusive to this projector.

Warning:

Be careful not to drop the lamp fixing screws inside of the projector. Don’t put a metal piece or flammable object 

into the projector. Using the projector with any foreign object present inside may result in electric shock or fi re. 

When you can’t remove the foreign object from the inside, contact your dealer for removal.

Be sure to install the lamp securely. When the lamp isn’t installed properly, it won’t illuminate. Improper installation 

may also result in fire.

Don’t shake the removed lamp or don’t lift it above your face. Your eyes may be injured by flying or falling glass 

fragments.

Don’t replace the VLT-HC7000LP lamp immediately after use because the lamp cover will be very hot. You may get burned. Turn 

off the power using the POWER button. After the lamp goes out, wait about two minutes until the intake and 

exhaust fans for cooling the lamp stop rotating. Then unplug the power cord, and wait at least one hour to allow 

the lamp to cool down enough to the touch.

Do not touch the VLT-HC7000LP lamp directly. It may break and cause injury or burn