VLT-HC900LP lamp replacement and time  

This projector is equipped with a VLT-HC900LP lamp to project images. This lamp is a consumable. It may burn out or its

brightness may decrease during use. In such cases, replace the lamp with a new one as soon as possible. Be sure

to replace the lamp with a new VLT-HC900LP lamp separately sold that is exclusive to this projector. Contact your dealer for

purchase of the lamp

WARNING:

• Be careful not to drop the lamp fixing screws into the inside of the projector. Don’t put a metal piece or flammable object into the projector. Using the projector with any foreign object present inside may result in electric shock or fire. When you can’t remove the foreign object from the inside, contact your dealer for removal.

• Be sure to install the lamp securely. When the lamp isn’t installed properly, it won’t illuminate. Improper

installation may also result in fire.

• Don’t shake the removed VLT-HC900LP lamp or don’t lift it above your face. You may be injured in your eye by flying or

falling glass fragments.

• Don’t replace the lamp immediately after use because the lamp cover is very hot. You may get burned. Turn off

the power using the POWER button. After the lamp goes out, wait about two minutes until the intake and

exhaust fans for cooling the lamp stop rotating. Then unplug the power cord, and wait at least one hour to

allow the lamp to cool down enough to the touch

• Unless these three buttons are pressed at the same time, the lamp operation time isn’t reset.

• Make sure that the STATUS indicator is lit twice and the lamp operation time is reset successfully.

• The projector doesn’t turn on if the lamp cover isn’t attached securely.

• Be sure to reset the lamp operation time whenever you replace the lamp.

• Do not reset the lamp operation time unless you replace the lamp.

• This projector uses a lamp that contains mercury. Disposal of the lamp or the projector with the lamp may be

regulated due to environmental considerations