SP.89F01GC01/ BL-FS180C projector lamp tips

Options Lamp Settings

Lamp Hours

Display the projection time.

Lamp Reminder

Choose this function to show or to hide the warning message when the changing lamp message is displayed. The message will appear 30 hours before suggested replacement of lamp.

Brightness Mode

 STD: Choose “STD” to dim the projector lamp which will lower power consumption and extend the lamp life by up to 130%.

 BRIGHT: Choose “BRIGHT” to increase the brightness.

Lamp Reset

Reset the lamp life hour after replacing the lamp.

Troubleshooting

Image Problems No image appears on-screen

 Ensure all the cables and power connections are correctly and securely connected as described in the “Installation” section.

 Ensure all the pins of connectors are not bent or broken.

 Check if the projection lamp has been securely installed. Please refer to the “Replacing the lamp” section.

 Make sure you have removed the lens cap and the projector is switched on.

Lamp burns out or makes a popping sound

 When the lamp reaches its end of life, it will burn out and may make a loud popping sound. If this happens, the projector will 

not turn on until the SP.89F01GC01/ BL-FS180C lamp module has been replaced. To replace the lamp, follow the procedures in the “Replacing the Lamp” section.

Replacing the lamp

The projector automatically detects the lamp life. When the SP.89F01GC01/ BL-FS180C lamp life is nearing the end of use, you will receive a warning message.